Decks That Take Stain Evenly
Deck staining in Galena for surfaces carrying layers of weathered finish
If the existing finish on your deck has weathered unevenly and new stain will not bond to the failing coats underneath, American Shield Painting strips the old finish and applies new stain in Galena. Decks on older houses in the region often carry several layers of old finish that have weathered unevenly, and stripping them back is what lets new stain take evenly. The owner is on site for the job, so the stripping and preparation are done before any stain goes on.
The existing finish is stripped off before new stain is applied, so the new coat bonds to bare wood rather than sitting on failing old finish. Boards are cleaned and allowed to dry, then stain is applied, with the method depending on the deck size and the condition of the wood after stripping.
Arrange an inspection to assess the existing finish and determine whether stripping is required.
What Stripping Accomplishes Before Staining
Stripping removes the accumulated layers of old stain and sealer that have broken down, exposing bare wood that can absorb the new stain uniformly. Boards are cleaned after stripping to remove residue, then allowed to dry fully so moisture does not interfere with stain penetration, and the new coat soaks into the grain rather than sitting on the surface where it will peel.
Once the work is finished, you see a deck with uniform color across all boards, no blotchy areas where old finish blocked absorption, and a stain layer that penetrates the wood rather than forming a film that will flake off.
The finish protects the wood from moisture and UV damage, and the deck surface feels smooth without the rough, peeling texture of failing coatings.
The service includes stripping, cleaning, drying time, and stain application. Power washing may be included in the quote or priced separately depending on the deck condition and the amount of residue removal required, so ask before booking.
Common Questions About This Service
Deck staining on older surfaces involves decisions about stripping methods, drying time, and stain selection. These answers address what happens during a typical project in the region.
How is old finish stripped from deck boards?
Old finish is removed with chemical strippers or sanding depending on the number of layers and the condition of the wood underneath, with the method chosen to expose bare wood without damaging the grain or leaving residue that would interfere with new stain absorption.
Why does the wood need to dry after cleaning?
Moisture in the wood prevents stain from penetrating evenly, so boards are allowed to dry fully after stripping and cleaning, with drying time depending on weather conditions and the porosity of the wood once the old finish is removed.
What type of stain is used on stripped decks?
The stain type depends on the wood species and the desired finish, with penetrating stains used on most decks because they soak into the grain and last longer than film-forming finishes that sit on the surface and peel as the wood expands and contracts.
When should a deck be restained after stripping?
Restaining intervals depend on sun exposure, foot traffic, and the type of stain used, but decks stripped to bare wood and stained properly typically hold finish longer than decks where new stain was applied over failing old coats without stripping.
What should you look for after the stain is applied?
The finish should appear uniform in color without light or dark patches, feel smooth without tacky spots where stain pooled instead of absorbing, and show no areas where the wood grain is still visible because the stain did not penetrate adequately.
The owner handles the stripping, prep and stain application himself. American Shield Painting also
stains decks in Freeport, Dubuque, Elizabeth, East Dubuque and Lancaster. Schedule a site visit to review your deck's condition and discuss the scope of stripping required.
